Roland GR-540 User Manual page 380

(1) Change the Name of the Second Cutting Machine
Follow the procedure below to connect a second machine. The same procedure can be used to connect a third
unit and any subsequent units.
Procedure
* Do not connect the USB cable at this stage.
Turn off the power of the machine.
While holding down [PINCH], switch on the power switch.
The screen shown in the following figure is displayed.
Press [ ] and [ ] to select a setting other than "A."
It is possible to select a value from "B" to "E." In this example, "B" is selected.
Press [ENTER].