Table of Contents
Advertisement
Cutting Corners Cleanly
<Over Cut>
This function cuts an extra 1 mm at the start and end of each line. It is effective when you want to produce
particularly sharp corners, for example when cutting thicker materials.
In most cases the over cut function should be set to [OFF]. Set it to [ON] when you want to ensure that
corners are cut cleanly. However, if the over cut function is enabled when cutting small characters or complex
shapes, areas of the material that are required may be cut. In such cases it should therefore be set to [OFF].
OFF
Factory default setting OFF
Options
Procedure
Make sure the material is loaded in the machine.
Press [MENU] several times to display the screen shown in the figure.
Press [ ] several times to display the screen shown in the figure.
ON
OFF, ON
Hide quick links:
Advertisement
Table of Contents
