Table of Contents
Advertisement
Click OK.
The cutting data is sent to the machine. When the machine receives the data, it automatically reads
the crop marks using a sensor, and then starts cutting.
If the sensor fails to read the crop marks
If the sensor fails to read the crop marks, the screen in the figure appears. If this screen appears, see
"Crop Marks Cannot be Read."
If this does not resolve the issue, refer to
"Cutting in Tool Mode (1),"
and
then perform positioning in tool mode.
Remove the cut material.
Removing the Material
This completes the cutting procedure.
Hide quick links:
Advertisement
Table of Contents
