Roland GR-540 User Manual page 267

Setting the Amount of Offset for the Tip of the
Blade
<OFFSET>
This setting lets you set the amount of offset for the tip of the blade. Set a value that matches the conditions for
the blade installed.
When using the included blade or equivalent parts, cutting can be performed using the factory default setting.
Factory default setting 0.250 mm
Setting range
Procedure
Make sure the material is loaded in the machine.
Press [MENU] several times to display the screen shown in the figure.
Press [ ] to display the screen shown in the figure.
(1) Offset amount
(2) Blade tip
(3) Blade centerline
0.000 to 1.000 mm (in 0.025 mm steps)