Table of Contents
Advertisement
Using Various Types of Materials
Using Roll Material
CAUTION
Loading Roll Material
Using Flat Material
If flat material is used, it must be at least 60 mm longer than the vertical size of the cutting data. This is the
length required for the pinch rollers to feed out the material to the front and rear.
Refer to the figure below and ensure that there are sufficient margins at the front and rear of the material.
Loading Flat Material
Never load media that weighs over 40 kg (88.19 lb.).
The machine may fail to withstand the weight, causing the machine to tip over
or the material to fall.
1: 30 mm or more
2: 30 mm or more
3: Pinch roller
4: Material-feed direction
Hide quick links:
Advertisement
Table of Contents
