Roland GR-540 User Manual page 390

the color and glossiness of the material.
Crop Marks/Tool Marks
Crop Marks Cannot Be Read
Cutting in Tool Mode (1)
Press any key to cancel setup and clear the
error message. Load the material correctly,
and then make it ready for cutting (setup
condition).
Loading Position of Material
Switch off the power and contact your authorized Roland DG Corp. dealer.
Install the cutting tool again.
Installing the Cutting Tool
An attempt was made to ready the machine
without loading material. The material was
removed when the machine was ready to
perform cutting. The material came loose
during cutting.
The cutting tool was installed in the
position for cutting perforated lines.