Roland GR-540 User Manual page 276

Setting the Speed of the Blade During Cutting
<UPSPEED>
This setting lets you set the speed for moving the blade to the next cutting position with the blade lifted off the
material during cutting operation.
When this is set to [AUTO], the blade moves at the speed specified by [SPEED]. Increasing [UPSPEED] shortens the
cutting time. When cutting material that is thinner or thicker than the standard material, it may be better to
decrease the speed to prevent problems such as the material being lifted up.
Factory default setting AUTO
Setting range
Procedure
Make sure the material is loaded in the machine.
Press [MENU] several times to display the screen shown in the figure.
Press [ ] to display the screen shown in the figure.
Press [ ].
10 to 50 cm/s (in 10 cm/s steps), AUTO