Setting the Direction of the Coordinate Axis for
Cutting
<ROTATE>
This setting lets you set the direction of the coordinate axis for cutting.
When set to [0deg] (default value), the origin is set to the lower-left corner of the material. When set to [90deg],
the origin is set to the lower-right corner of the material, and the data is rotated counterclockwise by 90 degrees.
Note that when [90deg] is selected, the coordinate axis changes.
The arrows in the following figures indicate the positive directions of the X and Y axes.
When Set to 0deg
When Set to 90deg
Factory default setting 0deg
Options
0deg or 90deg