Roland GR-540 User Manual page 346

The Cutting Lines Are Offset Inward from the Printing Position
This may be because the distance between the printed crop marks is shorter than the setting. In this case, set
the W and L values smaller than the settings to make the adjustment.
CAUTION
The values entered in the Crop Mark Adjustment dialog box are effective only when Fine adjustment in the
Printing Setup dialog box is enabled. All the entered values are cleared if Fine adjustment is disabled or if the
W and L values of Crop marks are changed.
If the Sensor Fails to Read the Crop Marks
If the sensor fails to read the crop marks, the screen in the figure appears. If this screen appears, proceed to
"Crop Marks Cannot Be Read."
If this does not resolve the issue, refer to
mode.
(1): Origin
(2): Cutting line
(3): Printing position
(1): Origin
(2): Cutting line
(3): Printing position
"Cutting in Tool Mode (1)," and then perform positioning in tool