Canon IMAGERUNNER 4570 Network Manual page 103

NOTE
•
The print application will be LPD and the print queue will be set to <LP> if the driver
has been installed according to the above procedures.
•
This machine enables you to specify print queues other than <LP>. You can also
use Raw as the print application. For instructions on how to change the settings,
see "Changing the Port after Installing the Driver," on p. 3-57.
I Changing the Port after Installing the Driver
1
Install Canon LPR2, and change the port settings.
If you do not want to use Canon LPR2, proceed to step 2.
For instructions on how to install Canon LPR2 and set ports, see Chapter 1,
"Using Canon LPR2," in the Canon LPR2 User's Guide (PDF manual). For
instructions on how to display the Canon LPR2 User's Guide, see the Network
Quick Start Guide.
If you use Canon LPR2, the port changes are complete.
IMPORTANT
If you use LPD, enter one of the following in [LPR Queue Name] in the [Add Port]
dialog box of Canon LPR2:
- LP
The machine prints according to its spool settings. Normally enter <LP> as a print
queue.
- SPOOL
The machine prints only after spooling a print job on the hard disk, regardless of
its spool settings.
- DIRECT
The machine prints without spooling a print job on the hard disk, regardless of its
spool settings.
NOTE
If you are using Windows 2000/XP/Server 2003, you can set LPD or Raw by using
the standard feature of your OS, without installing Canon LPR2. If you do not want
to use Canon LPR2, see steps 2 to 11.
2
Open the printer properties dialog box.
❑
If you are using Windows 2000, on the [Start] menu, point to [Settings] © click
[Printers].
❑
If you are using Windows XP Professional/Server 2003, on the [Start] menu,
click [Printers and Faxes].
Setting Up a Computer for Printing/Sending a Fax (Windows/UNIX)
3
3-57