Printer Connection Method - Canon IMAGERUNNER 4570 Network Manual

Printer Connection Method

Install the driver and specify the port for the machine, using the following
procedure.
NOTE
If Windows NT/2000/XP/Server 2003 is on your network, the following procedure enables
you to set up a print server for more efficient management of network printers. Once a
print server is set up, print jobs can be managed by the print server. Also, by setting up
an alternate driver for the print server, printer drivers can be installed in each computer
via the network.
For instructions on how to set print servers, see the following procedures indicated in the
manual for each driver. (The UFR II printer driver is not available for Windows NT.)
- If you want to use the PCL printer driver
See the procedure for alternative printer driver installation in Chapter 2, "Getting
Started," in the PCL Driver Guide.
- If you want to use the PS printer driver
See the procedure for alternative printer driver installation in Chapter 2, "Getting
Started," in the PS Driver Guide.
- If you want to use the UFR II printer driver
See the procedure for alternative printer driver installation in Chapter 2, "Getting
Started," in the UFR II Driver Guide.
- If you want to use the fax driver
See the procedure for alternative fax driver installation in Chapter 2, "Getting Started,"
in the Fax Driver Guide.
1
Check the settings for both <RX/Print Range> and <Setting/
Browsing Range> in [IP Address Range Settings], to see
whether the IP address of the computer in which a driver is to
be installed is permitted.
See step 22 in "TCP/IP Settings," on p. 3-4.
IMPORTANT
•
If the settings for both <RX/Print Range> and <Setting/Browsing Range> in [IP
Address Range Settings] do not permit the IP address, you cannot install a driver.
•
If the IP address of the computer is beyond the range of the permitted addresses
set for <RX/Print Range> after installing a driver, you cannot print from the
computer.
Setting Up a Computer for Printing/Sending a Fax
5
5-15