Canon IMAGERUNNER 4570 Network Manual page 109

NOTE
If you are using Windows NT 4.0, you can set LPD by using the standard service of
your operating system (Microsoft TCP/IP), without installing Canon LPR2. In this
case, you cannot set Raw. For instructions on how to install the Microsoft TCP/IP
Printing service, see steps 1 and 2 of "Installing a New Driver," on p. 3-61. For
instructions on how to change ports using the Microsoft TCP/IP Printing service,
see steps 2 to 9.
2
On the [Start] menu, point to [Settings] © click [Printers].
3
Right-click the icon of the printer you installed © click
[Properties].
4
Click the [Ports] tab to display the [Ports] sheet.
5
Click [Add Port] to open the [Printer Port] dialog box.
6
From [Available Printer Ports], select [LPR Port] © click [New
Port].
The [Add LPR compatible printer] dialog box opens.
IMPORTANT
If [LPR Port] is not displayed, you need to install the Microsoft TCP/IP Printing
service.
Click [Cancel] to close all dialog boxes © install the Microsoft TCP/IP Printing
service. After installing, start again from step 2.
For instructions on how to install the Microsoft TCP/IP Printing service, see steps 1
and 2 in "Installing a New Driver," on p. 3-61.
7
Enter the IP address or printer host name in [Name or address
of server providing lpd].
Setting Up a Computer for Printing/Sending a Fax (Windows/UNIX)
3
3-63