Canon IMAGERUNNER 4570 Network Manual page 213

Cause 2 TCP/IP network is not properly set up.
Remedy Confirm that the IP addresses are properly set up. If the IP addresses were set
using DHCP, BOOTP, or RARP, confirm that they are operating.
NOTE
Your computer may not be able to recognize the machine even though the IP address
settings are appropriate. This problem may be resolved by delaying the startup of
network communications for the machine. (See "Startup Time Settings," on p. 3-51.)
Cause 3 The computer that is printing is not properly set up.
Remedy Check the following:
•
Confirm that the proper printer driver is installed. If you are printing from
Windows, each computer must have a printer driver installed. For instructions
on how to install printer drivers, see the Driver Guide.
•
Confirm that the correct printer is set as the output destination for the
computer that is printing. Check the output destination in [Printer] in [Control
Panel].
•
If you are using LPD with Windows 98/Me, follow the procedures below to
confirm the spool settings: On the [Start] menu, point to [Settings] © click
[Printers]. Right-click the printer icon you are using © on the pop-up menu,
click [Properties]. Click the [Details] tab to display the [Details] sheet. Click
[Spool Settings] to open the [Spool Settings] dialog box. Confirm that [Spool
print jobs so program finishes printing faster] is selected. If it is not selected,
select it © click [OK].
Cause 4 The name of the file being printed is too long.
Remedy Normally LPR sends jobs either under the name of the application software
used for printing or under the file name. However, a job name longer than 255
characters cannot be sent to the printer. To correct this problem, rename the file
with a shorter name.
Cause 5 The IP address of the computer from which data (print/fax/I-fax job) is to be sent
to the machine is not permitted by the settings for [RX/Print Range] in [IP
Address Range Settings].
Remedy Check the settings for <RX/Print Range> in [IP Address Range Settings]. (See
step 22 in "TCP/IP Settings," on p. 3-4.)
Cause 6 An error message is displayed on the touch panel display of the machine.
Remedy After confirming the error message, see Chapter 8, "Troubleshooting," in the
Reference Guide and perform the necessary operations according to the error
message displayed.
Printing Problems and Remedies
8
8-5