Canon IMAGERUNNER 4570 Network Manual page 74

3
28
3-28 Protocol Settings
❑
Enter an IP address that exists on the network using
press [Start].
When you press [Start], the result of the PING command appears on the touch
panel display.
If this result is inappropriate, check the settings described in "Interface
Settings," on p. 2-7, and "TCP/IP Settings," on p. 3-4.
IMPORTANT
•
If you set the startup time of the machine's network function by following the
procedure in "Startup Time Settings," on p. 3-51, execute the PING command only
after the time set as the startup time passes (the default setting startup time is '60
seconds').
•
If you connect the machine to a switching hub, the machine may not be able to
connect to a network even though your network settings are appropriate. This
problem may be resolved by delaying the startup of network communications for
the machine. See "Startup Time Settings," on p. 3-51 for information on how to set
up the startup time.
❑
Press [Done] © press [M] or [L] until [SNTP Settings] appears © press [SNTP
Settings].
❑
Press [NTP Server Check].
<OK> is displayed if time synchronization is working correctly via SNTP.
NOTE
•
If <Error> is displayed, check the settings for [NTP Server Address] set in step 15.
•
Even if you perform [NTP Server Check], time settings are not updated. Check that
communications are possible between the machine and the NTP server.
Press [Done] repeatedly until the Additional Functions screen
closes.
(numeric keys) ©
-