®
VLT
HVAC Drive Operating Instructions
4.1.14. Motor connection for C1 and C2
Illustration 4.15: First terminate the motor earth, then Place motor U, V and W wires in terminal and tighten.
Please ensure that the outer insulation of the motor cable is removed under the EMC clamp.
4.1.15. Wiring Example and Testing
The following section describes how to terminate control wires and how to access them. For an
explanation of the function, programming and wiring of the control terminals, please see chapter,
How to programme the frequency converter.
4.1.16. Access to Control Terminals
All terminals to the control cables are located
underneath the terminal cover on the front of
the frequency converter. Remove the terminal
cover with a screwdriver.
MG.11.A4.02 - 09.10.06. VLT
®
is a registered Danfoss trademark
4. Electrical installation
Illustration 4.16: A2 and A3 enclosures
4
33