Danfoss VLT HVAC Operating Instructions Manual page 65

®
VLT HVAC Drive Operating Instructions
Function:
Select a variable for display in line 2. The op-
tions are the same as those listed for par. 0-20
Display Line 1.1 Small
0-24
Value:
Counter [kWh]
Function:
Select a variable for display in line 2. The op-
tions are the same as those listed for par. 0-20
Display Line 1.1 Small
0-37
Function:
In this parameter it is possible to write an in-
dividual text string for display in the LCP or to
be read via serial communication. If to be dis-
played permanently select Display Text 1 in
par. 0-20, 0-21, 0-22, 0-23 or 0-24,
Line XXX
to change a character. Use the ◂ and ▸ but-
tons to move the cursor. Then a character is
highlighted by a cursor, this character can be
changed. A character can be inserted by plac-
ing the cursor between two characters and
pressing ▴ for ▾.
0-38
Function:
In this parameter it is possible to write an in-
dividual text string for display in the LCP or to
be read via serial communication. If to be dis-
played permanently select Display Text 2 in
par. 0-20, 0-21, 0-22, 0-23 or 0-24,
Line XXX
to change a character. Use the ◂ and ▸ but-
tons to move the cursor. Then a character is
highlighted by a cursor, this character can be
changed. A character can be inserted by plac-
ing the cursor between two characters and
pressing ▴ for ▾.
.
Display Line 3 Large
.
Display Text 1
. Use the ▴ or ▾ buttons on the LCP
Display Text 2
. Use the ▴ or ▾ buttons on the LCP
MG.11.A4.02 - 09.10.06. VLT ®
6. How to programme the frequency converter
0-39 Display Text 3
Function:
In this parameter it is possible to write an in-
dividual text string for display in the LCP or to
be read via serial communication. If to be dis-
played permanently select Display Text 3 in
par. 0-20, 0-21, 0-22, 0-23 or 0-24,
Line XXX . Use the ▴ or ▾ buttons on the LCP
to change a character. Use the ◂ and ▸ but-
[1502]
tons to move the cursor. Then a character is
highlighted by a cursor, this character can be
changed. A character can be inserted by plac-
ing the cursor between two characters and
pressing ▴ for ▾.
0-70 Set Date and Time
Value:
2000-01-01 00:00 –
2099-12-01 23:59
Function:
Sets the date and time of the internal clock.
The format to be used is set in par. 0-71 and
0-72.
Display
NB!
This parameter does not display
the actual time. This can be read
in par. 0-89. The clock will not
begin counting until a setting
different from default has been
made.
0-71 Date Format
Value:
YYYY-MM-DD
DD-MM-YYYY
MM/DD/YYYY
Function:
Display
Sets the date format to be used in the LCP.
0-72 Time Format
Value:
24 H
12 H
is a registered Danfoss trademark
Display
6
2000-01-01
00:00
[0]
[1]
[2]
[*0]
[1]
65