Danfoss VLT HVAC Operating Instructions Manual page 32

4. Electrical installation
4.1.12. Motor connection for A5
4
Illustration 4.13: First terminate the motor earth, then place motor U, V and W wires in terminal and tighten.
Please ensure that the outer insulation of the motor cable is removed under the EMC clamp.
4.1.13. Motor connection for B1 and B2
Illustration 4.14: First terminate the motor earth, then Place motor U, V and W wires in terminal and tighten.
Please ensure that the outer insulation of the motor cable is removed under the EMC clamp.
32
MG.11.A4.02 - 09.10.06. VLT ® is a registered Danfoss trademark
®
VLT HVAC Drive Operating Instructions