VLT
®
HVAC Drive Instruction Manual
4.1.14. Motor connection for C1 and C2
Illustration 4.15: First terminate the motor ground, then place motor U, V and W wires in the terminal and
tighten them. Please ensure that the outer insulation of the motor cable is removed under the EMC clamp.
4.1.15. Wiring Example and Testing
The following section describes how to terminate and access control wires. For an explanation of
programming and wiring control terminals, please see the chapter entitled
adjustable frequency drive
.
MG.11.A4.22 - VLT
®
is a registered Danfoss trademark
4. Electrical installation
How to program the
39
4