Danfoss VLT HVAC Operating Instructions Manual page 51

®
VLT HVAC Drive Operating Instructions
•
•
•
MCT 10 Set-up Software supports Profibus DP-V1 via a Master class 2 connection. It makes it
possible to on line read/write parameters in a frequency converter via the Profibus network. This
will eliminate the need for an extra communication network.
Save Frequency Converter Settings:
1.
2.
3.
4.
All parameters are now stored in the PC.
Load Frequency Converter Settings:
1.
2.
3.
4.
5.
All parameter settings are now transferred to the frequency converter.
A separate manual for MCT 10 Set-up Software is available: MG.10.R2.02.
The MCT 10 Set-up Software Modules
The following modules are included in the software package:
Ordering number:
Please order the CD containing MCT 10 Set-up Software using code number 130B1000.
MCT 10 can also be downloaded from the Danfoss Internet: WWW.DANFOSS.COM, Business Area:
Motion Controls.
Simple and accurate documentation of frequency converter settings after commissioning.
Expanding an existing network
Future developed frequency converters will be supported
Connect a PC to the unit via USB com port. (Note: Use a PC, which is isolated from the
mains, in conjunction with the USB port. Failure to do so may damage equipment.)
Open MCT 10 Set-up Software
Choose "Read from drive"
Choose "Save as"
Connect a PC to the frequency converter via USB com port
Open MCT 10 Set-up software
Choose "Open"– stored files will be shown
Open the appropriate file
Choose "Write to drive"
MCT 10 Set-up Software
Setting parameters
Copy to and from frequency converters
Documentation and print out of parameter settings incl. diagrams
Ext. User Interface
Preventive Maintenance Schedule
Clock settings
Timed Action Programming
Smart Logic Controller Set-up
MG.11.A4.02 - 09.10.06. VLT ®
5. How to operate the frequency converter
is a registered Danfoss trademark
5
51