Danfoss VLT HVAC Operating Instructions Manual page 25

®
VLT HVAC Drive Operating Instructions
4.1.5. Mains connection for A2 and A3
Illustration 4.2: Firstly mount the two screws in the mounting plate, slide it into place and tighten fully.
Illustration 4.3: When mounting cables, first mount and tighten earth cable.
The earth connection cable cross section must be at least 10 mm
wires terminated separately according to EN 50178/IEC 61800-5-1.
MG.11.A4.02 - 09.10.06. VLT ® is a registered Danfoss trademark
4. Electrical installation
2
or 2 rated mains
25
4