Danfoss VLT HVAC Operating Instructions Manual page 48

Hide thumbs Also See for VLT HVAC:
Table of Contents

Advertisement

5. How to operate the frequency converter
The parameters can be accessed immediately unless a password has been created via par. 0-60,
0-61, 0-65 or 0-66.
Quick Setup
The parameter values can be changed using the up/down arrows when the value is flashing.
Select Main Menu by pressing the [Menu] key a number of times until the Main Menu LED is lit.
Select the parameter group [xx-__] and press [OK]
Select the parameter [__-xx] and press [OK]
If the parameter is an array parameter select the array number and press [OK]
Select the wanted data value and press [OK]
Navigation Keys [Back]
Arrow [ ] [ ]
within parameters.
5
[OK]
parameter.
Operation Keys
Keys for local control are found at the bottom
of the control panel.
[Hand on]
and it is now possible to enter the motor speed data by means of the arrow keys. The key can be
selected as
48
is used to set up the frequency converter using only the most essential parameters.
for stepping backwards
keys are used for manoeuvring between parameter groups, parameters and
is used for choosing a parameter marked by the cursor and for enabling the change of a
enables control of the frequency converter via the LCP. [Hand on] also starts the motor
Enable
[1] or
Disable
[0] via par. 0-40
MG.11.A4.02 - 09.10.06. VLT
®
VLT
HVAC Drive Operating Instructions
Illustration 5.4: Display example
Illustration 5.5: Operation keys of the numerical
CP (NLCP)
[Hand on] Key on LCP
.
®
is a registered Danfoss trademark
130BP046.10

Advertisement

Table of Contents
loading

Table of Contents