Port Link Configuration - HP ProLiant BL p-Class GbE2 Command Reference Manual

Port Link Configuration

Command: /cfg/port <port number>/gig
[Gigabit Link Menu]
Use these menu options to set port parameters for the port link.
Link menu options are described in the following table and display on the Gigabit port
configuration menus for the GbE2 Interconnect Switch. Using these configuration menus,
you can set port parameters such as speed, duplex, flow control, and negotiation mode for the
port link.
The following table describes the Gigabit Link Configuration Menu options.
Table 6-9: Gigabit Link Configuration Menu Options
Command
speed 10|100|1000|any
mode full|half|any
fctl rx|tx|both|none
auto on|off
cur
HP ProLiant BL p-Class GbE2 Interconnect Switch Command Reference Guide
HP CONFIDENTIAL Codename: Strawberry Part Number: 331404-001 Last Saved On: 7/17/03 12:57 PM
speed - Set link speed
mode - Set full or half duplex mode
fctl - Set flow control
auto - Set auto negotiation
cur - Display current gig link configuration
Description
Sets the link speed. Not all options are valid on all ports. The
choices include:
•
10 Mb/s
•
100 Mb/s
•
1000 Mb/s
•
"Any," for automatic detection (default)
Sets the operating mode. The choices include:
•
Full-duplex
•
Half-duplex
•
"Any," for automatic detection (default)
Sets the flow control. The choices include:
•
Receive (rx) flow control
•
Transmit (tx) flow control
•
Both receive and transmit flow control (default)
•
No flow control
Enables or disables auto-negotiation for the port.
Displays current port parameters.
The Configuration Menu
6-13