HP ProLiant BL p-Class GbE2 Command Reference Manual page 83

Table 6-2: System Configuration Menu Options
Command
snmp disable|read-only|read-write
wport <TCP port number>
notice <max 1024 char multi-line
login notice> <'-' to end>
bannr <string, maximum 80
characters>
mnet <IP subnet (such as
192.4.17.0)>
mmask <IP subnet mask (such as
255.255.0.0)>
tnet disable|enable
tnport <TCP port number>
hprompt disable|enable
bootp disable|enable
HP ProLiant BL p-Class GbE2 Interconnect Switch Command Reference Guide
HP CONFIDENTIAL Codename: Strawberry Part Number: 331404-001 Last Saved On: 7/17/03 12:57 PM
continued
Usage
Disables or provides read-only/write-read SNMP
access.
Sets the GbE2 Interconnect Switch port used for
serving GbE2 Interconnect Switch Web content.
The default is HTTP port 80.
Displays login notice immediately before the
"Enter password:" prompt. This notice can
contain up to 1024 characters and new lines.
Configures a login banner of up to 80 characters.
When a user or administrator logs into the GbE2
Interconnect Switch, the login banner is
displayed. It is also displayed as part of the
output from the /info/sys command.
Sets the base source IP address that allows
access to GbE2 Interconnect Switch
management through Telnet, SSH, SNMP, or the
GbE2 Interconnect Switch browser-based
interface. A range of IP addresses is produced
when used with mmask (below). Specify an IP
address in dotted-decimal notation.
This IP address mask is used with mnet to set a
range of source IP addresses allowed access to
GbE2 Interconnect Switch management
functions. Specify the mask in dotted-decimal
notation.
Enables or disables Telnet access to the
command line interface sessions. The default is
enable. This command is available only from a
local console connection.
Sets an optional Telnet server port number for
cases where the server listens for Telnet
sessions on a non-standard port. This command
is available from Telnet and a local console
connection, however, it is only valid to change
from a local connection.
Enables or disables displaying of the SNMP
system in the command line interface.
Enables or disables the use of BOOTP. If you
enable BOOTP, the GbE2 Interconnect Switch
will query its BOOTP server for all of the GbE2
Interconnect Switch IP parameters. The default is
enable.
The Configuration Menu
continued
6-5