Table of Contents
Advertisement
First-Time Configuration
Changing the Default Operator Password
The operator manages all functions of the GbE2 Interconnect Switch. The operator can reset
ports or the entire GbE2 Interconnect Switch. Operators can only effect temporary changes
on the GbE2 Interconnect Switch. These changes will be lost when the GbE2 Interconnect
Switch is rebooted/reset. Operators have access to the GbE2 Interconnect Switch
management features used for daily GbE2 Interconnect Switch operations. Because any
changes an operator makes are undone by a reset of the GbE2 Interconnect Switch, operators
cannot severely impact GbE2 Interconnect Switch operation.
By default, the operator account is disabled and has no password. This password cannot be
changed from the operator account. Only the administrator has the ability to change
passwords, as shown in the following procedure.
1. Connect to the GbE2 Interconnect Switch and log in using the admin password.
2. From the Main Menu, use the following command to access the Configuration Menu:
Main# cfg
3. From the Configuration Menu, use the following command to select the System Menu:
>> Configuration# sys
4. Enter the following command to set the operator password:
System# user/opw
5. Enter the current administrator password at the prompt.
Only the administrator can change the user password. Entering the administrator
password confirms your authority.
Changing OPERATOR password; validation required...
Enter current administrator password:
6. Enter the new operator password at the prompt:
Enter new operator password:
7. Enter the new operator password, again, at the prompt:
Re-enter new operator password:
8. Apply and save your changes:
System# apply
System# save
3-14
HP CONFIDENTIAL Codename: Strawberry Part Number: 331404-001 Last Saved On: 7/17/03 12:50 PM
HP ProLiant BL p-Class GbE2 Interconnect Switch Command Reference Guide
Advertisement
Table of Contents
