Debugging Options - HP ProLiant BL p-Class GbE2 Command Reference Manual

The Maintenance Menu

Debugging Options

Command: /maint/debug
[Miscellaneous Debug Menu]
The Miscellaneous Debug Menu displays trace buffer information about events that can be
helpful in understanding GbE2 Interconnect Switch operation. You can view the following
information using the Debug Menu:
•
Events traced by the management processor (MP)
•
Events traced to a buffer area when a reset occurs
If the GbE2 Interconnect Switch resets for any reason, the management processor (MP) trace
buffer is saved into the snap trace buffer area. The output from these commands can be
interpreted by HP technical support.
The following table describes the Miscellaneous Debug Menu options:
Table 9-4: Miscellaneous Debug Menu Options
Command
tbuf
snap
clrcfg
gea
9-4
HP CONFIDENTIAL Codename: Strawberry Part Number: 331404-001 Last Saved On: 7/17/03 1:11 PM
tbuf - Show MP trace buffer
snap - Show MP snap (or post-mortem) trace buffer
clrcfg - Clear all flash configs
gea - GEA 5690 Menu
Usage
Displays the management processor trace buffer. Header information
similar to the following is shown:
MP trace buffer at 13:28:15 Fri May 25, 2002; mask:
0x2ffdf748
The buffer information is displayed after the header.
Displays the management processor snap (or post-mortem) trace buffer.
This buffer contains information traced at the time that a reset occurred.
Deletes all flash configuration blocks. The next time the GbE2 Interconnect
Switch is rebooted, it returns to the factory default settings.
This menu is reserved for debugging purposes by HP technical support.
HP ProLiant BL p-Class GbE2 Interconnect Switch Command Reference Guide