15.3
Function Details
15.3.1
Function to read/write device when e-mail is received
Writing an MC protocol command in the message body of incoming mail enables device reading and writing.
After command execution, e-mail is returned to the send address to report the result of reading.
When using this function, check "Enable MC Protocol Command" in the built-in Ethernet port setting of the PC
parameter. (
Page 196, Section 15.2.1 (2))
Check also "Enable online change (FTP, MC Protocol)".
Project window
[Parameter]
[PLC Parameter]
CHAPTER 15 E-MAIL SEND/RECEIVE FUNCTION
[Built-in Ethernet Port Setting]
15
199