3.1
Setting Required for the CPU Module
(1) PLC parameter setting
Select the "Built-in Ethernet Port Setting" tab and set the parameters.
Project window
1.
1.
Set the IP address of the CPU module.
2.
Set MELSOFT connection.
Project window
Conf.] or [Open Setting] button
• For the "Ethernet Conf.", drag and drop the "MELSOFT Connection Module" from "Module List" to the left
side on the window. Select a protocol from "Protocol" depending on the target device.
• For the "Open Setting"
Item
Protocol
Open System
CHAPTER 3 CONNECTION WITH PROGRAMMING TOOL AND GOT
[Parameter]
[PLC Parameter]
[Parameter]
[PLC Parameter]
Select "TCP" or "UDP" depending on the connected device.
Select "MELSOFT Connection".
[Built-in Ethernet Port Setting]
2.
[Built-in Ethernet Port Setting]
Setting
3
[Ethernet
23