Mitsubishi L02CPU User Manual page 170

(3) Register Destination
(a) Setting of devices for communications
Set the devices for both transmission source and transmission destination. Up to 64 devices can be registered.
the
List" window as well to change the setting information.
Setting item
IP Address/Port No. Input
Format
Module Type
IP Address
Port No.
Network No.
Station No.
Remote Password
Host Station Port No.
Host Station No.
*1 Set the station number not to overlap the numbers set for other devices on the same Ethernet network (such as Ethernet
module, programming tool, and GOT).
168
This setting also can be done in the "Destination Setting List" window that will open by clicking
button in the "Simple PLC Communication Setting" window. Use the "Destination Setting
Description
Select the input format of IP address and port No.
Select the device for communications.
Set the IP address of the device.
Set the port No. of the device.
Set the network No. of the device (host station).
Set the station No. of the device.
If a remote password is set for the destination
device, the communication is possible by entering
the password.
Set the port No. of the host station.
Set the station No. of the host station.
Setting range
DEC/HEX
Page 169, Section 12.1 (3) (b)
0.0.0.1 to 223.255.255.254
0401 to 1387
H H
(0401 to 15AC
H
communication with FX3)
1 to 239
1 to 64
4 characters or less (one-byte
alphanumeric and special characters)
0401 to 1387
H H
(0401 to 15AC
H
communication with FX3)
*1
1 to 64
, 1392 to FFFE
H H
, 15B0 to FFFE for
H H H
, 1392 to EFFF
H H
, 15B0 to EFFF for
H H H