Mitsubishi L02CPU User Manual page 123

(2) Operation on the connected device (FTP client) side
The following describes the procedure and processing on the connected device side, which is required for using
the FTP server function of the CPU module.
Various FTP commands and how to enter each of them are also shown.
(<ret> indicates an input of the CR, Enter, or Return key.)
Start
Start the FTP client. (ftp <ret>)
Login to the CPU module (open "CPU module's IP address" <ret>)
Is the
NO
FTP communication
port subject to remote
password
check?
YES
(quote password-unlock
Unlock the remote
password. "remote password" <ret>)
YES
Is file transfer
completed?
NO
YES
Write files
to the FTP server?
NO
File reading
No file conversion is notified.
(binary <ret>)
(dir <ret>
Check the file list.
or ls <ret>)
NO
Does the read
target file exist?
YES
Is File
NO
password 32 set for the
target file?
YES
(quote passwd-rd
Enter a file password.
"read password" <ret>)
(get "file name" <ret>)
Read the file.
CHAPTER 9 FILE TRANSFER FUNCTION (FTP SERVER)
File writing
No file conversion is notified.
(binary <ret>)
(dir <ret> or
Check the file list.
ls <ret>)
NO
Does the write
target file exist?
YES
NO
Can it be overwritten?
YES
Is File
NO
password 32 set for the
target file?
YES
(quote passwd-wr
Enter a file password.
"write password" <ret>)
(delete "file name" <ret> or
Delete or rename the file.
rename "current file name"
"new file name" <ret>)
Write the file.
(put "file name" <ret>)
NO Is remote
password enabled
for FTP?
YES
(quote password-lock
Lock the remote password.
<ret>)
Disconnect from
(bye <ret>)
the CPU module.
End
9
121