Mitsubishi L02CPU User Manual page 172

(c) Setting for each device for communications
The settings vary depending on the device for communications.
: Setting required, : Setting required if the password is set for destination device for communications, : Setting not required
Device for communications
MELSEC-Q/L (Built-in Ethernet
Function)
MELSEC-Q/L (Ethernet Module)
MELSEC-QnA (Ethernet Module)
MELSEC-A (Ethernet
Module)/MELSEC-FX3 (Ethernet
Block/Adapter)
*1 Setting of the host station is required.
*2 For the "MELSEC-Q/L (Ethernet Module)" and "MELSEC-QnA (Ethernet Module)," settings of these items in "Simple
PLC Communication Setting" are required because these modules perform communication processing using the
network No. and station No.
170
IP Address




Router
Hub
Ethernet
Network No. 1 Network No. 1
Station No. 1 Station No. 2
The settings must be configured in
simple PLC communication setting.
Setting item
Network No. Station No.
 
*1*2 *1*2
 
*1*2 *1*2
 
 
Data flow
Hub
Network No. 1
Station No. 1
The settings must be configured in
simple PLC communication setting.
Remote
Port No.
Password



*1

Network No. 1
Station No. 2



