Mitsubishi L02CPU User Manual page 39

3.
Set connections used for MC protocol communication.
Project window
Conf.] or [Open Setting] button
• For "Ethernet Conf.", drag and drop "SLMP Connection Module" from "Module List" to the left side on the
window. Select a protocol from "Protocol" depending on the target device. Set the port number of the host
station in "Port No.". (Setting range: 1025 to 4999, 5010 to 65534) Do not specify 5000 to 5009 because
these ports are used by the system. (
• For the "Open Setting"
Item
Protocol Select TCP or UDP depending on the target device.
Open System Select "MC Protocol".
Set the port number of the host station. (Setting range: 0401
Host Station Port No.
(1025 to 4999, 5010 to 65534))
*1 Do not specify 1388 to 1391
H
2)
When the "Enable online change (FTP, MC protocol)" setting is disabled, if the CPU module in the RUN state receives a data
write request from the target device, data will not be written and an NAK message will be returned.
[Parameter] [PLC Parameter]
Page 221, Appendix 2)
*1
(5000 to 5009) because these ports are used by the system. (
H
CHAPTER 5 MC PROTOCOL COMMUNICATION
[Built-in Ethernet Port Setting]
Description
to 1387 , 1392
H H
[Ethernet
5
to FFFE
H H
Page 221, Appendix
37