Seat catch and helmet hooks
Opening (fig. 29)
Fit the ignition key into the lock (4) and turn the key
clockwise about 1/4 turn until the rear end of the seat
lifts up. Pull the seat backwards to slide it off its front
On the rear end of the compartment underneath the
seat, there is the helmet fastening cable (2) (see page
63). Insert the cable into the helmet and insert the ends
of the cable into one of the two hooks (3). Leave the
helmet hanging outside (fig. 30) and refit the seat.
This system is intended to lock your helmet safely
when you park your motorcycle. Never leave the helmet
hanging from the hook when riding or it may get in the
way and make you lose control of the motorcycle.
Make sure that all parts are arranged and secured
properly inside the compartment under the seat. Slide
the front ends of the seat bottom underneath the frame
U-bolt and push down on the rear end of the seat until
you hear the catch click. Make sure the seat is firmly
secured to the frame and take the key out of the lock.