Beam Setting - Ducati ST4s Owner's Manual

Hide thumbs Also See for ST4s:
Table of Contents

Advertisement

Available languages

Available languages

Beam setting (fig. 89)
When checking beam setting, put the motorcycle
upright. Tyres should be inflated at the correct pressure
and one person should be sitting astride the motorcycle,
keeping it at right angles to its longitudinal axis. Place the
motorcycle opposite a wall or a screen, 10 meters apart
from it, then draw a horizontal line dictated by headlamp
center and a vertical one in line with the longitudinal axis
of motorcycle.
If possible, perform this check in dim light.
Switch on the low beam. The height of the light spot
(measured at the upper limit between dark and lighted-up
area) should not exceed 9/10
of headlamp center.
Note
The procedure described here is in compliance with
the "Italian Standard" establishing the maximum height
of the light beam. Owners in other countries will adapt
said procedure to the provisions in force in their
countries.
Beam vertical adjustment (fig. 90)
This adjustment can be made with buttons (A) and (B) on
the instrument panel, enter "Beam vertical setting" mode
(see pag 22).
th
of the height from ground
10 m
A
B
km/h
miles
mph
km/L
mpgal
9
x
x
10
E
fig. 89
fig. 90
85

Advertisement

Table of Contents
loading

This manual is also suitable for:

St4s abs

Table of Contents