VETRON 5000 Instruction Book page 17

1
2
Push the X-button at the machine head, the red light illuminates showing the active "blocked mode",
or power o the machine before inserting the needles. Failure to comply produces a risk of injury in
case of an unintentionally machine operation.
CAUTION!
Only use needles from the system intended for the machine.
(see at VETRON GENERAL INSTRUCTION MANUAL – TECHNICAL DATA)
01. Push the X-button at the machine head, the red light illuminates showing
the active "blocked mode", or power o the machine.
02. Loosen the screws
03. Push the needles
of the right needle points to the right and the left needle to the left.
04. Fasten the screws
05. Push the X-button or switch on the machine again and follow the instructions
displayed in the control panel.
Before activating the machine by the X-button make sure to remove sewing material
or other items below the sewing feet if necessary and follow the instructions displayed
in the control panel.
12. INSERTING THE NEEDLE (TWO NEEDLE MACHINE)
CAUTION! RISK OF INJURY!
1 .
2
fully in until they stop. Make sure that the groove
1
again .
CAUTION:
INSTRUCTION BOOK
3
3
INSTRUCTION BOOK VETRON 5000 17
-2-2