VETRON 5000 Instruction Book page 16

INSTRUCTION BOOK
12. INSERTING THE NEEDLE (ONE NEEDLE MACHINE)
-1-2
1
2
Push the X-button at the machine head, the red light illuminates showing the active
"blocked mode", or power o the machine before inserting the needle. Failure to comply
produces a risk of injury in case of an unintentionally machine operation.
CAUTION!
Only use needles from the system intended for the machine.
(see at VETRON GENERAL INSTRUCTION MANUAL – TECHNICAL DATA)
01. Push the X-button at the machine head, the red light illuminates showing
the active "blocked mode", or power o the machine.
02. Loosen the screw 1 .
03. Push the needle 2 fully in until it stop. Make sure that the groove
on the needle is to the right side.
04. Fasten the screw 1 again.
05. Push the X-button or switch on the machine again and follow the instructions
displayed in the control panel.
CAUTION:
Before activating the machine by the X-button make sure to remove sewing material
or other items below the sewing feet if necessary and follow the instructions displayed
in the control panel.
16 INSTRUCTION BOOK VETRON 5000
CAUTION! RISK OF INJURY!
3
3