VETRON 5000 Instruction Book page 23

Push the X-button at the machine head, the red light illuminates showing the active
"blocked mode", or power o the machine. Failure to comply produces a risk of injury
in case of an unintentionally machine operation.
The safety clutch is integrated in the main drive module to protect the hook from damage.
Causes of damage could be for example thread jamming, needle break or incorrect operation.
If the safety clutch has released, perform the following procedure:
01. Power o the machine at the main switch.
02. Remove the cause of the disorder.
03. Tilt the machine to the back, open the right cover to get access to the mechanical handwheel.
04. Take the 3 mm allen key of the accessories and stuck it in screw
Turn the hand wheel until the key is touching the machine housing (picture left).
05. Take the 5 mm allen key of the accessories and put it in the hand wheel gap (picture right).
Turn the hand wheel until the safety clutch is noticeable engaging.
06. Check the needle bar rise. (refer to chapter 3.12. of the adjustment manual).
If confirmed, the machine is ready for use again.
NOTE!
Push the X-button or switch on the machine again and follow the instructions
displayed in the control panel.
INSTRUCTION BOOK
1
DANGER! RISK OF INJURY!
17. ENGAGING THE SAFETY CLUTCH
1 .
INSTRUCTION BOOK VETRON 5000 23