Setting The Ethernet Speed - Ricoh SP6330 Hardware Manual

6. Press the [Menu] key to return to the initial screen.
7. Print a configuration page to confirm the settings.
• For details about printing the configuration page, see "List/Test Print Menu", Software Guide.

Setting the Ethernet Speed

You can set the speed that the printer will use for Ethernet communications. In most cases, this should be
left on the default setting, [Auto Select]. This setting allows two interfaces to automatically determine the
optimum speed when they are connected.
Router/HUB
[10Mbps Half
Duplex]
10 Mbps half
duplex
10 Mbps full
duplex
100 Mbps half
duplex
100 Mbps full
duplex
auto-
negotiation
(auto
selection)
• Connection cannot be established if the selected Ethernet speed does not match your network's
transmission speed.
• The auto-negotiation mechanism allows two interfaces to automatically determine an optimum
Ethernet speed as soon as they are connected. We recommend you select [Auto Select].
[10Mbps Full
Duplex]
-
-
- -
- -
-
Printer
[100Mbps [100Mbps Full
Half Duplex] Duplex]
- -
- -
-
-
-
Ethernet Configuration
4
[Auto Select]
-
-
69