Setting The Ethernet Speed - Ricoh Aficio SP C242DN Hardware Manual

7. Press the [ ] or [ ] key to display [DHCP], and then press the [OK] key.
IPv6 Config.:
DHCP
8. Press the [ ] or [ ] key to select [On], and then press the [OK] key.
DHCP:
On
The address will be detected by the printer
9. Press the [Menu] key.
10. If you are requested to restart the printer, turn off the printer, and then turn it back on.
11. Print a configuration page to confirm the settings made.
• For details about printing the configuration page using control panel, see p.36 "Test Printing".

Setting the Ethernet Speed

You can set the speed that the printer will use for Ethernet communication. For normal usage, the default
setting [Auto Select] is suitable and does not need to be changed. This setting allows two connected
interfaces to automatically determine the optimum speed that they will communicate at.
Router/HUB
[10Mbps
Half D.]
10Mbps Half
Duplex
10Mbps Full
Duplex
100Mbps Half
Duplex
100Mbps Full
Duplex
auto-
negotiation
(auto selection)
Printer
[10Mbps Full [100Mbps
D.] Half D.]
Ethernet Configuration
[100Mbps [Auto Select]
Full D.]
4
55