Initial Start-Up Safety; Instructions To Be Observed Before Commissioning Or Recommissioning; Checking Installation And Operating Conditions - KAESER M43 Service Manual

7 Initial Start-up
7.1
Further information
7.2
7.3
50
7 Initial Start-up
7.1 Safety
Safety
Here you will find instructions for safe commissioning of the machine.
Warning instructions are located before a potentially dangerous task.
Basic safety instructions
1. Follow the instructions in chapter "Safety and Responsibility".
2. Commissioning work may only be carried out by authorized operating and maintenance per‐
sonnel.
Information on authorized personnel are found in chapter 3.4.2.
Information on dangers and their avoidance are found in chapter 3.5.
Instructions to be observed before commissioning or recommis‐
sioning
The initial start-up of every machine takes place at the factory. Every machine is also given a
trial run and passes a careful check.
Incorrect or improper commissioning can cause injury to persons and damage to the machine.
➤ Commissioning may only be carried out by authorized installation and service personnel who
have been trained on this machine.
➤ Remove all packing materials and tools on and in the machine.
➤ Observe the machine during the first few hours of operation to ensure that it is operating cor‐
rectly.

Checking installation and operating conditions

➤ Check and confirm all the items in the checklist before starting the machine.
Function
➤ Are the operators fully conversant with safety regulations?
➤ Have all the positioning conditions been fulfilled?
➤ Is there sufficient cooling oil in the separator tank?
➤ Is there sufficient oil in the engine?
➤ Is the maintenance indicator on the air intake filters (engine and
compressor) OK?
➤ Is there sufficient coolant in the coolant expansion tank?
➤ Is there sufficient fuel in the fuel tank?
➤ Is there sufficient tool oil in the tool lubricator? (option ea, ec)
➤ Is there enough antifreeze in the frost protector? (option ba)
Engine SM = engine manufacturer's service manual.
Service Manual Screw Compressor
M43
See chapter Confirmed?
–
5
10.4.1
Engine SM
10.3.2,
10.4.6
10.3.1
Engine SM
10.7.1
10.7.2
No.: 9_9432 02 E