Changing The Oil Filter; Fig. 35 Changing The Oil Filter - KAESER M43 Service Manual

10.4.4
Material
Precondition
Fig. 35
92
10 Maintenance
10.4 Compressor

Changing the oil filter

Spares
Receptacle
Cleaning cloths
The machine is shut down.
The machine is fully vented, the pressure gauge reads 0 bar.
Machine cooled down.
All compressed air consumers are disconnected and the air outlet valves are open.
The negative cable to the battery is disconnected.
CAUTION
There is risk of burns from hot components and escaping oil.
➤ Wear long-sleeved clothing and gloves.
Changing the oil filter
Ambient temperature acquisition
1
Combination valve
2
Changing the oil filter
1. Prepare a receptacle.
2. Loosen the filter by turning anticlockwise
3
3. Carefully clean sealing surfaces using lint-free cloth.
4. Lightly oil the new filter's gasket.
5. Turn the oil filter clockwise by hand to tighten.
6. Check the oil level in the oil separator tank.
Top up if necessary.
7. Reconnect the negative cable to the battery.
Dispose of old cooling oil and any materials or parts contaminated with oil according to envi‐
ronment protection regulations.
Starting the machine and carrying out a trial run
1. Start the machine and run in idle up to operating temperature.
2. Close the outlet valves.
Service Manual Screw Compressor
M43
Oil filter
3
Direction of rotation to unscrew the oil filter.
4
and catch any escaping oil.
4
No.: 9_9432 02 E