Table of Contents
Advertisement
Precondition
46
6
Installation
6.3
Adjusting the chassis
2. Remove both bolts
3
3. Draw off the eye
from the towbar
1
Fitting the ball coupling
The towing eye has been removed.
The assembly condition as shown in the centre graphic in 13 has been achieved.
The ball coupling is complete with sleeve.
1. Push back the protective sleeve
2. Bring the bush
of the overrun damper
4
■
Push a metal rod through the towbar
■
Withdraw the rod.
3. Press the saddle
down over the towbar
7
4. Push the ball coupling
5. Align the holes for the fixing bolts
6. Use a metal rod if necessary to align the holes.
7. Push the fixing bolts
8. Screw on and tighten the self-locking nuts
Service Manual
Screw Compressor
M43
.
.
6
if necessary.
8
to the fixing position so holes align.
5
and bush
6
.
6
on to the towbar
.
9
6
.
3
through the holes in the coupling
3
.
2
to align the holes.
4
, the saddle
, and the towbar
9
7
.
6
No.: 9_9432 02 E
Advertisement
Table of Contents
