Traffic Control; Port Protected; Port Isolation Configuration - Delta DVS-328 series User Manual

D V S M a n a g e d I n d u s t r i a l R a c k Mo u n t E t h e r n e t S wi t c h U s e r Ma n u a l

3.7 Traffic Control

You can see the MAC addresses which the Delta switch had learned, and configure a port which is to be
protected or unprotected in this group.
IMPORTANT:
Make sure that you save the configuration in the Save Configuration
page after you have applied the configuration changes. (Save
ConfigSave Configuration) If you do not save the configuration,
then the configuration will be cleared after the switch is rebooted.

3.7.1 Port Protected

A protected port does not forward traffic to any other protected ports on the switch, but can forward traffic to
unprotected ports on the switch.
 Enable: Select one interface or more interfaces by clicking the square.
 Disable: Click second time to clear the interface.

3.7.2 Port Isolation Configuration

This function supports two mode group which are isolated or community.When enabled, the member port in the
group cannot forward its engress traffic to any other members in the same group.The ingress traffic from a port
in isolated group can be forwarded to anyone in the same VLAN that are not in an isolated group.

Port Isolation Configuration

Group Name
Specify the Port Isolation group name, and the name string can be up to 24 bytes of
non-blank characters.
Group ID
Specify the Port Isolation group ID, and the range of group is 1 to 24.
Group Mode
Specify the Port Isolaion group mode.
 Isolated: The members in the group cannot forward its engress traffic to any other
member ports in the same group.
 Community: Each member port can forward traffic to other mebers in the same
group, but not to member ports in other group.
3 - 7 8
Description Factory default
None
None
None