Trap Flags - Delta DVS-328 series User Manual

Trap Configuration
Community Name
Enter a case-sensitive string. The maximum length is 16 characters. The maximum
trap is 10.
Version
Specify the SNMP version that is used for the trap community:
 SNMP v1: Uses SNMP v1 to send traps to the trap community.
 SNMP v2c: Uses SNMP v2c to send traps to the trap community.
Protocol
Specify the IP version that is used for the trap community:
 IPv4: Sends traps to an IPv4 address. Input an IPv4 address in the Address field.
 IPv6: Sends traps to an IPv6 address. Input an IPv6 address in the Address field.
Address
Enter an IPv4 or IPv6 address according to the selection in the Protocol drop-down list.
For an IPv6 address, enter the address in the
xxxx:xxxx:xxxx:xxxxx:xxxx:xxxx:xxxx:xxxx format.

3.2.1.3 Trap Flags

After you configure the trap communities, you also need to configure the SNMP traps which the switch can
generate and send. When the switch detects the active trap which is an identified condition, a trap will be sent
to the trap communities.
Description
C h a p t e r 3 F e a t u r e d F u n c t i o n s
Factory default
None
None
None
None
3 - 3 7