Snmp V3; User Configuration - Delta DVS-328 series User Manual

D V S M a n a g e d I n d u s t r i a l R a c k Mo u n t E t h e r n e t S wi t c h U s e r Ma n u a l
Trap Flags
Authentication
Specify whether authentication traps are enabled.
 Enable: Specify the switch which sends authentication trap messages.
 Disable: Specify the switch which does not send authentication trap messages.
Cold Start
Specify whether cold-start traps are enabled.
 Enable: Specify the switch which sends cold-start trap messages.
 Disable: Specify the switch which does not send cold-start trap messages.
Warm Start
Specify whether warm-start traps are enabled.
 Enable: Specify the switch which sends warm-start trap messages.
 Disable: Specify the switch which does not send warm-start trap messages.
Link Up/Down
Specify whether link status traps are enabled.
 Enable: Specify the switch which sends link status trap messages when a link
comes up or goes down. This is the default setting.
 Disable: Specify the switch which does not send link status trap messages.
Spanning Tree
Specify whether spanning tree traps are enabled.
 Enable: Specify the switch which sends spanning tree trap messages.
 Disable: Specify the switch which does not send spanning tree trap messages.
Password Change
Specify whether Password Change traps are enabled.
 Enable: Specify the switch which sends Password Change trap messages.
 Disable: Specify the switch which does not send Password Change messages.
IP Address Change
Specify whether IP Address Change traps are enabled.
 Enable: Specify the switch which sends IP Address Change trap messages.
 Disable: Specify the switch which does not send IP Address Change messages.
Loopback-Detection
Specify whether Loopback-Detection traps are enabled.
 Enable: Specify the switch which sends Loopback-Detection trap messages.
 Disable: Specify the switch which does not send Loopback-Detection messages
Redundancy
Specify whether Redundancy traps are enabled.
 Enable: Specify the switch which sends Redundancy trap messages.
 Disable: Specify the switch which does not send Redundancy messages
POOLUTL
Specify whether POOLUTL traps are enabled.
 Enable: Specify the switch which sends POOLUTL trap messages.
 Disable: Specify the switch which does not send POOLUTL messages

3.2.2 SNMP v3

SNMP v3 primarily added security and remote configuration enhancements.The authentication in SNMP v1
and v2c uses a password (community string) sent in clear text between a manager and an agent. But the
SNMP v3 message contains security parameters which are encoded as an octet string. You can choose the
authentication protocol which you need for each user account.

3.2.2.1 User Configuration

The following default users are preconfigured for SNMP v3:

admin: All admin users can access data with the read/write permission.

guest: All IP guest users can access data with the read-only permission.
3 - 3 8
Description Factory default
Enable
Enable
Enable
Enable
Disable
Disable
Enable
Enable
Enable
Disable