Delta DX-3001 Series Instruction Sheet

DX-3001 Series
EN Instruction Sheet
安裝說明
TW
安装说明
CN
Warning! This unit contains a replaceable battery.
CAUTION: Risk of explosion if battery is replaced with the incorrect battery type. Dispose of used batteries according to the
manufacturer's instructions.
This product is intended to be supplied by an UL Listed dc source suitable for use at Tma 70 degree C whose output meets SELV
circuit and LPS which is separated from the primary circuit by double insulation or reinforced insulation, and is rated 12-48Vdc, 0.83A
max
 This instruction sheet only provides information on electrical specifications, general specifications, installation and
EN
wiring.
 此安裝手冊只提供電氣規格、一般規格、安裝及配線。
TW
 此安装手册只提供电气规格、一般规格、安装及配线。
CN
EN Please refer to the DX-3001 Series user manual for more information.
TW 詳細資料請參考 DX-3001 系列使用手冊 CN 详细资料请参考 DX-3001 系列用户手册
EN SIM Card Installation
EN 1. Insert a paper clip or a SIM-eject tool into the hole beside the tray and pop open your
device's SIM tray,
2. After you remove or transfer your SIM card, insert the tray completely and in the same
orientation that you removed it (it will fit only one way).
Note : DX-3001 does not support automatic SIM card hot-swapping and must
power off for SIM card to be recognized.
請使用迴紋針或 SIM 卡退出工具插入托盤旁的孔，SIM 卡托盤將彈出裝置
TW
1.
請將托盤以取出時的相同方向（只有一個方向會吻合）完全插入
2.
注意：DX-3001 不支援 SIM 卡熱拔插，請勿帶電操作！
1. 将回形针或 SIM 卡弹出工具插入托架旁边的孔中，SIM 卡托架將弹出设备。
CN
2. 請按取出托架时的同一方向完全插入托架（只有方向正确才能插入） 。
注意：DX-3001 不支持 SIM 卡热拔插，请勿带电操作！
EN DIN-Rail Mounting
EN Mounting 1. Hook the upper end of the DIN clip on the Devicc onto the DIN-Rail.
Mounting 2. Gently push the device toward the DIN-Rail, til they connected.
Removal 1. Insert the flat-blade screwdriver into the DIN clip and pull the DIN clip downward.
Removal 2. Pull the DX-3001 out to remove it from the DIN-Rail.
安裝: 1. 將後背的金屬安裝配件扣住 DIN-Rail。
TW
安裝: 2. 向內推直到金屬彈簧夾與 DIN-Rail 完全緊合。
取下: 1. 將一字起子插入金屬彈簧夾下的洞孔並向下拉。
取下: 2. 拉起底部即可順勢取出。
TW SIM 卡安裝
TW 軌道式安裝
CN SIM 卡安裝
CN 卡轨式安装