Network Settings - Honeywell hus-nvr-1032-e User Manual

Honeywell
Only "Administrator" user is able to manage role authority options.

Network Settings

Click Network Settings in Figure 5-65 to enter the Network Settings screen and where
there are 3 options: "Basic", "Multicast" and "HUS VMS" as shown in the following figure:
Figure 5-83 Network Settings
Basic
Click "Basic" and the below window is displayed:
Figure 5-84 Network Settings
This screen contains the following items:
Obtain an IP address automatically— Select it to automatically retrieve IP address via the
DHCP server. Click Save and it displays "IP Address", "Mask" and "Gateway" values after a
few seconds. Make sure NVR has access to the DHCP server which is running on the
Ethernet network.
Use the following IP adress—Select it to allow user to configure "IP address", "Subnet
Mask" and "Gateway" manually.
Max User(s) — Specify the maximum number of simultaneously on-line users allowed (≤32
users).
When finished, click Save.
Network Failure Recovery—Click to enble this function. When it is enabled, all the cameras
start 7*24 hours manual recording.
69