Inverter; Grid/Genset - Ingeteam INGECON SUN STORAGE 1Play 3 Installation And Operation Manual

Display control
Parameter
VNOMINAL Storage system rated voltage (V).
CAPACITY Storage system (C20) capacity, in Ah.
I CHARGE Maximum storage system charge current, in amps.
I DISCHARGE Maximum storage system discharge current, in amps.
TEMP. COMP. Storage system voltage compensation constant as a function of temperature (V/ºC).
V ABSORPTION Storage system absorption voltage (V).
V FLOTATION Storage system flotation voltage (V).
V EqUALIzATION Storage system equalization voltage (V).
T ABSORPTION Duration of absorption charge, in minutes. Time for which the storage system must be
maintained at the absorption voltage.
T EqUALIzATION Duration of equalization charge, in minutes. Time for which the storage system must be
maintained at the equalization voltage.
N.EqU. CYCLES Number of cycles to carry out an automatic equalization.

20.7.2. Inverter

From this menu the parameters of the inverter/charger can be set.
Parameter
RMS VOLTAGE RMS voltage generated (V).
FREqUENCY Frequency of generated voltage (Hz).
AC PHASE Phase (R, S, T or single phase) to be generated by the inverter. The single phase will be
configured by default.

20.7.3. Grid/Genset

Type of grid
This menu is for selecting and configuring the type of auxiliary grid/genset input to be used in the installation.
>
The symbol points to the option selected. To select the desired option and configure it, press
once it is highlighted.
If the option selected is GENERATOR, the following parameters must be set:
Parameter
RATED POWER Auxiliary generator rated power, in watts. Obtain this information from the generator
manufacturer.
VAC MIN Minimum AC voltage of the generator, in volts. Obtain this information from the generator
manufacturer.
VAC MAx Maximum AC voltage of the generator, in volts. Obtain this information from the generator
manufacturer.
FAC MIN Minimum AC frequency of the generator (Hz).
FAC MAx Maximum AC frequency of the generator (Hz).
If the option selected is GRID, the country in which the unit is installed must be set.
By default the voltage and frequency values are set in accordance with the standards in the selected country.
Should these values be modified, Ingeteam accepts no liability for any consequences which may occur as a result
of this modification.
Manual connection
Allows the inverter to be manually connected to the auxiliary grid/genset immediately. The unit will continue to run
until the shut-down is ordered by the same method.
ABH2013IQM01_A - Installation and Operation Manual
Explanation
Explanation
Explanation
Ingeteam
DE
EN
ES
FR
IT
PT
on the option
95