Device Status - Hirschmann BAT54-F User Manual

2 - Ethernet port data (DA)
3 - Power (P)
4 - WLAN1
5 - WLAN2
6 - M1
Meaning of the LEDs
The behavior of the LEDs is described below:
Blinking means that the LED switches on and off at regular intervals
in the color specified.
Flashing means that the LED lights up very briefly in the color
specified, then is switched off for a much longer time (about 10x as
long).
Flashing inversely means the reverse. Here the LED is on for a long
period in the color specified and is only briefly interrupted.
Flickering means that the LED switches on and off at irregular
intervals.

Device status

The LEDs shown in the table below provide information about conditions
which affect the operation of the entire device.
P (green/
red LED)
Green on continuously
Red blinking (slowly)
Green/red blinking (quickly)
Red blinking (quickly)
WLAN 1, WLAN 2
(green/red LEDs)
Off
Green
Green flashing inversely
Green blinking
Green flickering
Red flickering
Red blinking
52
Power
Device is ready for operation.
Charge lock active (see "Dual-Band Industrial Access Point /
Access Client / Access Bridge BAT54-Rail" user manual)
Unprotected configuration (no password set)
Hardware error detected.
WLAN connection and WLAN data traffic
of internal WLAN modules
No WLAN network defined or WLAN module deactivated. No
beacons sent from the WLAN module.
At least one WLAN network defined and WLAN module
activated. Beacons sent from the WLAN module.
Number of flashes = number of connected WLAN stations and
P2P radio lines, then there is a break.
DFS scanning or another scan procedure.
TX data traffic.
Error in WLAN detected (TX error, e.g. transmission error due
to bad connection).
Hardware error detected in WLAN module.
BAT-F, BAT-Rail, BAT54, BAT300
Release 02 07/10