2.5.2
Pole mounting
The BAT-F devices are suitable for pole mounting with the additional BAT-F
pole mounting set
The BAT-F pole mounting set is designed for:
Pole diameter: 37 mm to 60 mm
Maximum permitted wind load: 220 km/h.
Figure 4: BAT-F pole mounting set
2.6
DIN rail mounting (BAT-Rail)
Mount the device on a 35 mm DIN rail in accordance with DIN EN 60175.
Attach the upper snap-in guide of the device into the DIN rail and press it
down against the DIN rail until it snaps into place.
Note: The shielding ground of the industrial connectable twisted pair lines is
connected to the lower panel as a conductor.
BAT-F, BAT-Rail, BAT54, BAT300
Release 02 07/10
(see on page 62
„Accessories").
33