10/100 Mbit/S Twisted Pair Connection - Hirschmann BAT54-F User Manual

(5) (1)
TX+ 1
RX+ 2
TX- 3
RX- 4
(6)
(5) (2)
TX+ 1
RX+ 2
TX- 3
RX- 4
(6)
(5) (3)
TX+ 1
RX+ 2
TX- 3
RX- 4
(6)
(5) (4)
TX+ 1
RX+ 2
TX- 3
RX- 4
(6)
Figure 17: Patch cables for operating the device
(1) - Connection cables M12-4 on M12-4, crossed
(2) - Connection cables M12-4 on M12-4, 1 to 1
(3) - Connection cables M12-4 on RJ45, crossed
(4) - Connection cables M12-4 on RJ45, 1 to 1
(5) - M12 (MDI)
(6) - Shield
(7) - M12 (MDI)
(8) - M12 (MDI-X via autocrossing port)
(9) - RJ45, MDI (terminal device)
(10) - RJ45, MDI-X (Switch)
2.12.2

10/100 Mbit/s twisted pair connection

In the BAT-Rail, the 10/100 Mbit/s twisted pair connections are RJ45
sockets.
10/100 Mbit/s ports enable the connection of terminal devices or independent
network segments according to the IEEE 802.3 100BASE-TX / 10BASE-T
standard.
These ports support:
Autonegotiation
Autopolarity
Autocrossing (if autonegotiation is activated)
100 Mbit/s half-duplex mode, 100 Mbit/s full duplex mode
10 Mbit/s half-duplex mode, 10 Mbit/s full duplex mode
BAT-F, BAT-Rail, BAT54, BAT300
Release 02 07/10
(7)
1 TX+
2 RX+
3 TX-
4 RX-
(6)
(8)
1 RX+
2 TX+
3 RX-
4 TX-
(6)
(9)
1 TX+
2 TX-
3 RX+
6 RX-
(6)
(10)
1 RX+
2 RX-
3 TX+
6 TX-
(6)
45